AMCNTENCLR1

Disable control bits for the auxiliary activity monitors event counters, AMEVCNTR1<n>.

Configuration

External register AMCNTENCLR1 bits [31:0] are architecturally mapped to AArch64 System register AMCNTENCLR1_EL0[31:0].

External register AMCNTENCLR1 bits [31:0] are architecturally mapped to AArch64 System register AMCNTENSET1_EL0[31:0].

External register AMCNTENCLR1 bits [31:0] are architecturally mapped to AArch32 System register AMCNTENCLR1[31:0].

External register AMCNTENCLR1 bits [31:0] are architecturally mapped to AArch32 System register AMCNTENSET1[31:0].

It is IMPLEMENTATION DEFINED whether AMCNTENCLR1 is implemented in the Core power domain or in the Debug power domain.

This register is present only when FEAT_AMUv1 is implemented. Otherwise, direct accesses to AMCNTENCLR1 are RES0.

Attributes

Field descriptions

Bits [31:16]

P<n>, bit [n], for n = 15 to 0

Activity monitor event counter disable bit for AMEVCNTR1<n>.

When N is less than 16, bits [15:N] are RAZ, where N is the value in AMCGCR.CG1NC.

Possible values of each bit are:

P<n>	Meaning
0b0	When read, means that AMEVCNTR1<n> is disabled.
0b1	When read, means that AMEVCNTR1<n> is enabled.

The reset behavior of this field is:

On an AMU reset, this field resets to 0.

Accessing AMCNTENCLR1

If there are no auxiliary monitor event counters implemented, reads of AMCNTENCLR1 are RAZ. Software must treat reserved accesses as RES0. See 'Access requirements for reserved and unallocated registers'.

Note

There are no implemented auxiliary activity monitor event counters when AMCFGR.NCG == 0b0000.

Accesses to this register use the following encodings:

When FEAT_AMU_EXT32 is implemented

Accessible at offset 0xC24 from AMU

Accesses on this interface are RO.

31	30	29	28	27	26	25	24	23	22	21	20	19	18	17	16	15	14	13	12	11	10	9	8	7	6	5	4	3	2	1	0
RES0																P15	P14	P13	P12	P11	P10	P9	P8	P7	P6	P5	P4	P3	P2	P1	P0

AMCNTENCLR1, Activity Monitors Count Enable Clear Register 1